Supreme
3D
manuals
The SUPREME 3D is a pure
aerobatic model in large scale. Pilots should have experience of full house
aerobatic models and have begun to practise pattern aerobatic manoeuvers before
flying this model.
With one of the suggested power plants installed, this model is capable of
highly realistic aerobatics combined with low noise levels. If the 26cc petrol
engine is installed, the fuel tank supplied in the pack should be replaced with
a type compatible with petrol.
The model responds accurately to the pilotīs control commands thanks to the
carefully selected moment arms and the wing section employed. However, to fly
the SUPREME 3D
successfully the pilot must have prior experience with full-house aerobatic
power models.
Assembling the model is very simple, involving just joining the wing panels,
installing the fin and tailplane, and fitting the engine and RC components.
The model is of conventional all-wood construction, i.e. the fuselage, wing and
tail panels are strong built-up structures, adequately reinforced at critical
areas, and supplied ready-made and factory-covered in film.
The cowl and wheel spats are moulded in GRP, and are supplied pre-painted.
Slop-free control surface linkages are a pre-requisite for precise aerobatics,
and this is achieved by installing the servos immediately adjacent to the
control surfaces, in order to provide as direct a linkage as possible.
Specification
Recommended Engine 1.20 to 1.60, glowfuel or gasoline
Wingspan
approx. 1800 mm
Overall length approx. 1700 mm
Wing area approx. 60.7 dmē
Tailplane area approx. 15.5 dmē
Total surface area approx. 76.2 dmē
All-up weight according to fittings, approx. 5500
 |
 |
 |
|
RC functions Rudder Elevator Aileron Throttle |
Contents -Assembly instructions with stage photos in German, English and French. Ready-made, film-covered fuselage, wing and tail panels, GRP cowl, wheel spats, undercarriage, tailwheel unit, wheels, spinner, fueltank, pilot figure, canopy, small items, linkage hardware pack. |